Ip Source-Route - Dell S4810 Reference Manual

•
•
•
•
You cannot use the VRF attribute of this command to configure routes in a
management VRF. When a specific VRF is deleted, all the configured static routes
corresponding to that VRF are automatically removed.
Related show ip route
Commands

ip source-route

Enable Dell Networking OS to forward IP packets with source route information in the header.
S4810
Syntax
ip source-route
To drop packets with source route information, use the no ip route-source
command.
Defaults Enabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
866
When the interface goes down, Dell Networking OS withdraws the route.
When the interface comes up, Dell Networking OS re-installs the route.
When recursive resolution is "broken," Dell Networking OS withdraws the route.
When recursive resolution is satisfied, Dell Networking OS re-installs the route.
— views the switch routing table.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
IPv4 Routing