Redistribute Ospf - Dell S4810 Reference Manual

Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
pre-Version
6.2.1.1

redistribute ospf

Redistribute routing information from an OSPF process.
S4810
Syntax
redistribute ospf process-id [match external {1 | 2} | match
internal | metric metric-value] [route-map map-name]
To disable redistribution, use the no redistribute ospf process-id [match
external {1 | 2} | match internal | metric metric-value]
[route-map map-name] command.
Parameters
process-id
match external
{1 | 2}
match internal
metric metric-
value
route-map
map-name
Defaults Not configured.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
1400
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Enter a number that corresponds to the OSPF process ID to
redistribute. The range is from 1 to 65355.
(OPTIONAL) Enter the keywords match external then the
numbers 1 or 2 to indicated that external 1 routes or external
2 routes should be redistributed.
(OPTIONAL) Enter the keywords match internal to
indicate that internal routes should be redistributed.
(OPTIONAL) Enter the keyword metric then a number as
the metric value. The range is from 0 to 16.
(OPTIONAL) Enter the keywords route-map then the name
of a configured route map.
Introduced on the S6000.
Routing Information Protocol (RIP)