Dell S4810 Reference Manual page 1514

Hide thumbs Also See for S4810:

Table of Contents

Not configured.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.4.

The source-interface interface attribute is applicable for both the SSH

client as well as the COPY (SCP) commands. Using these attributes the client

session tags an error to the user during run time, in case there is a mismatch

between this command and the ip ssh vrf command.

Dell(conf)#ip ssh source-interface tengigabitethernet 0/36

Dell(conf)#do ssh 10.10.10.2 -l admin

Dell(conf)#no ip ssh source-interface

Specify a VRF for an outgoing SSH connections.

ip ssh vrf vrf-name

Enter the following keywords and slot/port or number

information:

For a 100/1000 Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16838.

For the Null interface, enter the keywords null 0.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a ten-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Introduced on the S-Series and Z-Series.