Show Logging - Dell S4810 Reference Manual

The following describes the two supported log messages formats:
•
•
Example
Dell(conf)#logging version ?
<0-1> Select syslog version (default = 0)
Dell(conf)#logging version 1

show logging

Display the logging settings and system messages logged to the internal buffer of the switch.
S4810
Syntax
show logging [number | history [reverse][number] | reverse
[number] | summary]
Parameters
number
history
reverse
summary
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
1598
0 – Displays syslog messages format as described in RFC 3164, The BSD syslog
Protocol
1 – Displays SYSLOG message format as described in RFC 5424, The Syslog
Protocol
(OPTIONAL) Enter the number of messages displayed in the
output. The range is from 1 to 65535.
(OPTIONAL) Enter the keyword history to view only
information in the Syslog history table.
(OPTIONAL) Enter the keyword reverse to view the Syslog
messages in FIFO (first in, first out) order.
(OPTIONAL) Enter the keyword summary to view a table
showing the number of messages per type and per slot. Slots
*7* and *8* represent RPMs.
EXEC
EXEC Privilege
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Simple Network Management Protocol (SNMP) and Syslog