Port Monitoring
The port monitoring feature allows you to monitor network traffic by forwarding a copy of each
incoming or outgoing packet from one port to another port.
The commands in this chapter are supported on the S4810 platform.
Important Points to Remember
•
Port monitoring is supported on physical ports and logical interfaces, such as Port Channels and
virtual local area networks (VLANs).
•
The monitoring (destination, "MG") and monitored (source, "MD") ports must be on the same switch.
•
In general, a monitoring port should have no ip address and no shutdown as the only
configuration; Dell Networking operating software permits a limited set of commands for monitoring
ports; display them using the ? command. A monitoring port also may not be a member of a VLAN.
•
A total of 4 MG may be configured in a single port-pipe.
•
MG and MD ports can be reside anywhere across a port-pipe.
•
Dell Networking operating software supports multiple source ports to be monitored by a single
destination port in one monitor session.
•
One monitor session can have only one MG port.
NOTE: The monitoring port should not be a part of any other configuration.
description
Enter a description of this monitoring session.
S4810
Syntax
description {description}
To remove the description, use the no description {description}
command.
Parameters
description
Defaults
none
Port Monitoring
Enter a description regarding this session (80 characters
maximum).
43
1297