Ip Ssh Server Vrf - Dell S4810 Reference Manual

Defaults Default listening port is 22.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage This command enables the SSH server and begins listening on a port. If a port is
Information not specified, listening is on SSH default port 22.
Example
Dell# conf
Dell(conf)# ip ssh server port 45
Dell(conf)# ip ssh server enable
Dell#
Related show ip ssh
Commands

ip ssh server vrf

Configure an SSH server on either a specific VRF or a management VRF.
S4810
Syntax
ip ssh server vrf {management | vrf-name}
1512
NOTE: If you enable FIPS mode, you can only select
version 2.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: Starting with Dell Networking OS Release 9.2(0.0), SSH server is
enabled by default.
— displays the ssh information.
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
Security