Show Storm-Control Unknown-Unicast - Dell S4810 Reference Manual

show storm-control unknown-unicast

Display the storm control unknown-unicast configuration.
S4810
Syntax
show storm-control unknown-unicast [interface]
Parameters
interface
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.2(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.5.1.0
1622
(OPTIONAL) Enter one of the following interfaces to display
the interface specific storm control configuration:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then y the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Storm Control