Snmp-Server Vrf - Dell S4810 Reference Manual

Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage The oid-tree variable is a full sub-tree starting from 1.3.6 and cannot specify the
Information
name of a sub-tree or a MIB. The following Example configures a view named
rview that allows access to all objects under 1.3.6.1.
Example
Dell# conf
Dell#(conf) snmp-server view rview 1.3.6.1 included
Related show running-config
Commands

snmp-server vrf

Configures an SNMP agent to bind to a specific VRF.
S4810
Syntax
snmp-server vrf vrf-name
To undo the SNMP agent configuration, use the no snmp-server vrf vrf-
name command.
Parameters
vrf vrf-name
Defaults Not Enabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage
Use this command to bind an SNMP agent to a VRF. The SNMP agent processes
Information
the requests from the interfaces that belong to the specified VRF. If no VRF is
specified, then the default VRF is used.
Simple Network Management Protocol (SNMP) and Syslog
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
snmp — displays the SNMP running configuration.
Enter the keyword vrf and then the name of the VRF to
associate an SNMP agent with that VRF.
Introduced on the S-Series and Z-Series.
1579