Advertise Med Guest-Voice-Signaling - Dell S4810 Reference Manual

To return to the default, use the no advertise med guest-voice {vlan-id
layer2_priority DSCP_value} | {priority-tagged number} command.
Parameters
vlan-id
layer2_priority
DSCP_value
priority-tagged
number
Defaults Unconfigured.
Command CONFIGURATION (conf-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Related
protocol lldp (Configuration)
Commands
debug lldp interface
show lldp neighbors

advertise med guest-voice-signaling

To advertise a separate limited voice service for a guest user when the guest voice control packets use a
separate network policy than the voice data, configure the system.
S4810
Syntax
advertise med guest-voice-signaling {vlan-id layer2_priority
DSCP_value} | {priority-tagged number}
To return to the default, use the no advertise med guest-voice-signaling
{vlan-id layer2_priority DSCP_value} | {priority-tagged number}
command.
1084
Enter the VLAN ID. The range is from 1 to 4094.
Enter the Layer 2 priority. The range is from 0 to 7.
Enter the DSCP value. The range is from 0 to 63.
Enter the keywords priority-tagged followed the Layer 2
priority. The range is from 0 to 7.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series and E-Series.
— enables LLDP globally.
— debugs LLDP.
— displays the LLDP neighbors.
Link Layer Discovery Protocol (LLDP)