Dell S4810 Reference Manual page 877

Hide thumbs Also See for S4810:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 9.0.0.0

Version 8.3.11.1

Version 8.1.1.0

Version 7.6.1.0

Version 7.5.1.0

The following describes the show hosts command in the following example.

Default domain...

Name/address

Name servers

IPv4 Routing

EXEC Privilege

Introduced on the S6000.

Added support for IPv6 addresses.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

Displays the domain name (if configured).

States if DNS is enabled on the system.

If DNS is enabled, the Name/Address lookup is domain

If DNS is not enabled, the Name/Address lookup is static

Lists the name servers, if configured.

Displays the host name assigned to the IP address.

Classifies the entry as one of the following:

perm — the entry was manually configured and will not

temp — the entry was learned and will time out after 72

hours of inactivity.

Also included in the flag is an indication of the validity of the

ok — the entry is valid.

ex — the entry expired.