Stack-Unit Portmode - Dell S4810 Reference Manual

Defaults auto
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.11.1
Version 8.1.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Usage This command is found on the Management interface only.
Information
Related
interface ManagementEthernet
Commands
(either the Primary or Standby RPM).
duplex (10/100 Interfaces)
the speed set to 10/100.
management route
interface or a forwarding router.

stack-unit portmode

You can split a single 40G port into four-10G ports.
S4810
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit
number
Defaults Disabled.
794
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S55, S60, and S4810
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series.
— configures the Management port on the system
— configures duplex mode on physical interfaces with
— configures a static route that points to the Management
Enter the stack member unit identifier of the stack member
to reset. For the S4810, the range is from 0 to 11.
Enter the port number of the 40G port to be split. Enter one
of the following port numbers: 48, 52, 56, or 60.
Interfaces