Match Mac Access-Group - Dell S4810 Reference Manual

Command CONF-CLASS-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage To access this command, enter the class-map command. After the class map is
Information
identified, you can configure the match criteria.
Use this command to match an IP class-map against a single VRF ID .
Related class-map
Commands

match mac access-group

Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
S4810
Syntax
match mac access-group {mac-acl-name}
Parameters
mac-acl-name
Defaults none
Command CLASS-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.5.1.0
Quality of Service (QoS)
Introduced on the S-Series and Z-Series.
— identifies the class map.
Enter a MAC ACL name. Its contents is used as the match
criteria in the class map.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Available on the C-Series and S-Series.
Added support for the DSCP Marking option.
1343