Queue Egress - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

Version 8.2.1.0

Version 7.6.1.0

Use this command to specify the name of the output QoS policy. Once output

policy is specified, rate-shape, scheduler strict, bandwidth-percentage, and WRED

can be defined. This command enables the qos-policy-output configuration mode

—(conf-qos-policy-out).

When rate-shape in QoS policy is applied both on queue level and aggregate

mode, the queue-based shaping occurs first followed by the aggregate rate

bandwidth-percentage

queue egress

Assign a WRED Curve to all eight egress Multicast queues or designate the percentage for the Multicast

bandwidth queue.

queue egress multicast linecard {slot number port-set number |

all} [wred-profile name | multicast-bandwidth percentage]

To return to the default, use the no queue egress multicast linecard

{slot number port-set number | all} [wred-profile name |

multicast-bandwidth percentage] command.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Policy name character limit increased from 16 to 32.

Introduced on the C-Series and S-Series.

Introduced on the E-Series.

— assigns weight to the class/queue.

— assigns yellow or green drop precedence.

Enter the keyword linecard then the line card slot number.

Enter the keywords port-set then the line card's port pipe.

The range is from 0 or 1.

Enter the keyword all to apply to all line cards.

Quality of Service (QoS)