Debug Isis Adj-Packets - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant FTOS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Entering debug isis enables all debugging parameters.

To display all debugging information in one output, use this command. To turn off

debugging, you normally enter separate no forms of each command. To disable all

debug messages for IS-IS at once, enter the no debug isis command.

debug isis adj-packets

Enable debugging on adjacency-related activity such as hello packets that are sent and received on IS-IS

adjacencies.

debug isis adj-packets [interface]

To turn off debugging, use the no debug isis adj-packets [interface]

Intermediate System to Intermediate System (IS-IS)

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

(OPTIONAL) Identifies the interface type slot/port as one of

the following:

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a VLAN, enter the keyword vlan then a number from