Snmp-Server View - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

You cannot modify the FIPS mode if SNMPv3 users are already configured and

present in the system. An error message is displayed if you attempt to change the

FIPS mode by using the fips mode enable command in Global Configuration

mode. You can enable or disable FIPS mode only if SNMPv3 users are not

previously set up. Otherwise, you must remove the previously configured users

before you change the FIPS mode.

Dell# snmp-server user privuser v3group v3 encrypted auth md5

9fc53d9d908118b2804fe80e3ba8763d priv aes128

d0452401a8c3ce42804fe80e3ba8763d

show snmp user

snmp-server view

Configure an SNMPv3 view.

snmp-server view view-name oid-tree {included | excluded}

To remove an SNMPv3 view, use the no snmp-server view view-name oid-

tree {included | excluded} command.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 9.2(0.0)

— Displays the information configured on each SNMP user name.

Enter the name of the view (not to exceed 20 characters).

Enter the OID sub tree for the view (not to exceed 20

characters).

(OPTIONAL) Enter the keyword included to include the MIB

family in the view.

(OPTIONAL) Enter the keyword excluded to exclude the

MIB family in the view.

Introduced on the S6000.

Introduced on the M I/O Aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Introduced on the S4820T.

Simple Network Management Protocol (SNMP) and Syslog