Default-Metric - Dell S4810 Reference Manual

To return to the default values, use the no default-information originate
command.
Parameters
always
metric metric-
value
route-map
map-name
Defaults Disabled. Metric: 1.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Usage The default route must be present in the switch routing table for the default-
Information information originate command to take effect.

default-metric

Change the default metric for routes. To ensure that all redistributed routes use the same metric value,
use this command with the redistribute command.
S4810
Syntax
default-metric number
To return the default metric to the original values, use the no default-metric
command.
Routing Information Protocol (RIP)
(OPTIONAL) Enter the keyword always to enable the switch
software to always advertise the default route.
(OPTIONAL) Enter the keyword metric then a number as
the metric value. The range is from 1 to 16. The default is 1.
(OPTIONAL) Enter the keywords route-map then the name
of a configured route-map.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1383