Dell S4810 Reference Manual page 885

Version 8.3.7.0
Version 8.1.1.0
Version 7.9.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage The following describes the show ip fib command shown in the following
Information
example.
Field
Destination
Gateway
First-Hop
Mac-Addr
Port
VId
Index
EC
Example
Dell>show ip fib linecard 12
Destination
Port
---------------------------------------------------------------
-----------------
3.0.0.0/8
00:01:e8:00:03:ff So 2/8 0 60260 0
3.0.0.0/8
00.10.10.0/24
00:01:e8:00:03:ff So 2/8 0 11144 0
100.10.10.1/32
00:00:00:00:00:00 CP
100.10.10.10/32 via 100.10.10.10, So 2/8 100.10.10.10
00:01:e8:00:03:ff So 2/8 0 0
101.10.10.0/24
00:00:00:00:00:00 RP2
101.10.10.1/32
00:00:00:00:00:00 CP
101.10.10.10/32 via 101.10.10.10, So 2/9 101.10.10.10
00:01:e8:01:62:32 So 2/9 0 1
Dell>
IPv4 Routing
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced VRF on the E-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Lists the destination IP address.
Displays either the word "direct" and an interface for a
directly connected route or the remote IP address used to
forward the traffic.
Displays the first hop IP address.
Displays the MAC address.
Displays the egress-port information.
Displays the VLAN ID. If no VLAN is assigned, zero (0) is
listed.
Displays the internal interface number.
Displays the number of ECMP paths.
Gateway
VId Index EC
via 100.10.10.10, So 2/8 100.10.10.10
via 101.10.10.10, So 2/9
Direct, So 2/8 0.0.0.0
via 127.0.0.1 127.0.0.1
Direct, So 2/9 0.0.0.0
via 127.0.0.1 127.0.0.1
First-Hop
0 3276 0
0
0 11145 0
0 3277 0
0
Mac-Addr
885