Dell S4810 Reference Manual page 879

vrf instance
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.7.0
Version 8.1.1.2
Version 8.1.1.0
Version 7.9.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage The following describes the show ip cam command shown in the following
Information
example.
Field
Index
Destination
EC
CG
V
C
Next-Hop
VId
IPv4 Routing
(OPTIONAL) E-Series Only: Enter the keyword vrf then the
VRF instance name to show CAM information as it applies to
that VRF instance.
EXEC
EXEC Privilege
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale E600i.
Introduced on the E-Series ExaScale.
Introduced VRF on the E-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the CAM index number of the entry.
Displays the destination route of the index.
Displays the number of equal cost multipaths (ECMP)
available for the default route for non-Jumbo line cards. For
Jumbo line cards, displays 0,1 when ECMP is more than
eight.
Displays 0.
Displays a 1 if the entry is valid and a 0 if the entry is for a
line card with Catalog number beginning with LC-EF.
Displays the CPU bit. 1 indicates that a packet hitting this
entry is forwarded to the CP or RP2, depending on Egress
port.
Displays the next hop IP address of the entry.
Displays the VLAN ID. If the entry is 0, the entry is not part of
a VLAN.
879