Ipv6 Neighbor - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 8.3.11.1

Version 8.3.7.1

ipv6 neighbor

Configure a static entry in the IPv6 neighbor discovery.

ipv6 neighbor {ipv6-address} {interface interface}

{hardware_address}

To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6

neighbor {ipv6-address} {interface interface} command.

ipv6-address

To remove all neighbor entries learned on a specific

interface, enter the keyword interface then the interface

type and slot/port or number information of the interface:

For a Fast Ethernet interface, enter the keyword

fastEthernet then the slot/port information.

• For a Port Channel interface, enter the keywords port-

channel then a number.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN, enter the keyword vlan then the VLAN ID.

The range is from 1 to 4094.

EXEC Privilege

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Enter the IPv6 address of the neighbor in the x:x:x:x::x

NOTE: The :: notation specifies successive hexadecimal

fields of zero.

Neighbor Discovery Protocol (NDP)