Negotiation Auto - Dell S4810 Reference Manual

Defaults Enabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.2
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage When you configure keepalive, the system sends a self-addressed packet out of
Information the configured interface to verify that the far end of a WAN link is up. When you
configure no keepalive, the system does not send keepalive packets and so the
local end of a WAN link remains up even if the remote end is down.

negotiation auto

Enable auto-negotiation on an interface.
S4810
Syntax
negotiation auto
To disable auto-negotiation, use the no negotiation auto command.
Defaults Enabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
756
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Introduced on the S6000.
Interfaces