Transform-Set - Dell S4810 Reference Manual

Dell(conf-crypto-policy)#

transform-set

Specify the transform set the crypto policy uses.
S4810
Syntax
transform-set transform-set-name
To delete a transform set from the crypto policy, use the no transform-set
transform-set-name command.
Parameters
transform-set-
name
Defaults none
Command CONFIG-CRYPTO-POLICY
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2)
830
Source mask
Source port
Destination address
Destination mask
Destination port
source-interface name :
source-interface num
Enter the name for the crypto policy transform set.
Introduced on the Z9000, S4810, and S4820T.
: /32
: 0
: 1.1.1.2
: /32
: 23
:
Internet Protocol Security (IPSec)