ip multicast-msdp
Enable MSDP.
S4810
Syntax
ip multicast-msdp
To exit MSDP, use the no ip multicast-msdp command.
Defaults
Not configured.
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 6.2.1.1
show ip msdp
Display the MSDP peer status, SA cache, or peer summary.
S4810
Syntax
show ip msdp {peer peer address | sa-cache | summary}
Parameters
peer peer
address
sa-cache
summary
Defaults
Not configured.
Multicast Source Discovery Protocol (MSDP)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Enter the keyword peer then the peer address in a dotted
decimal format (A.B.C.D.).
Enter the keywords sa-cache to display the Source-Active
cache.
Enter the keyword summary to display an MSDP peer
summary.
1113