Dell S4810 Reference Manual page 1285

Hide thumbs Also See for S4810:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.1.1.0

Version 7.8.1.0

The following describes the show ip pim interface command shown in the

following example.

E600-7-RPM0#show ip pim interface

172.21.200.254 Gi 7/9

PIM-Sparse Mode (PIM-SM)

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Lists the IP addresses of the interfaces participating in PIM.

List the interface type, with either slot/port information or ID

(VLAN or Port Channel), of the interfaces participating in

Displays the PIM version number and mode for each

interface participating in PIM:

v2 = PIM version 2

S = PIM Sparse mode

Displays the number of PIM neighbors discovered over this

Displays the query interval for Router Query messages on

that interface (configured with ip pim query-interval

Displays the Designated Router priority value configured on

the interface (use the ip pim dr-priority command).

Displays the IP address of the Designated Router for that

Interface Ver/ Nbr

Mode Count Intvl Prio

172.21.200.254