Jam At Tray 3 (Illegal Settings) - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Jam at Tray 3 (Illegal Settings)

3-26
The Registration Sensor is not turned On within the specified time. The
following troubleshooting procedure applies to this error.
Applicable Chain Link
Jam at Tray 3 (Illegal Settings)
Initial Actions
Try picking paper from a different tray.
Check the paper path for obstructions or debris.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL9.2.13
Right Side Harness, PL10.1.12
Optional Feeder, PL13.2.9
Feed Roller, PL13.2.10
Optional Feeder Board, PL13.3.6
Optional Feeder Drive, PL13.3.10
Optional 550-Sheet Feeder, PL13.4.1
Retard Roller, PL13.4.10
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the paper condition.
2. Is the paper damaged?
1. Check the paper setting.
2
2. Does the paper in use match with
the paper settings on the printer
Control Panel?
3 Does the error still occur when
printing?
1. Reseat Tray 3.
4
2. Does the error still occur when
printing?
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit and Feeder" on
page 10-11
"Map 4 - LVPS and MCU Board" on
page 10-13
"Map 6 - Optional 550-Sheet Feeder" on
page 10-15
"Main Drive" on page 10-28
"Optional 550-Sheet Feeder Wiring
Diagram" on page 10-45
Yes
Replace the
paper.
Go to step 3.
Go to step 4.
Go to step 5.
Phaser 6180MFP Multifunction Printer Service Manual
No
Go to step 2.
Correct the
paper size
settings on the
printer Control
Panel.
Go to step 3.
Complete.
Complete.