Motor Error (Optional 550-Sheet Feeder) - Xerox Phaser 6180MFP Service Manual

Motor Error (Optional 550-Sheet Feeder)

Phaser 6180MFP Multifunction Printer Service Manual
The Optional 550-Sheet Feeder Motor has failed. The following
troubleshooting procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL9.2.13
Right Side Harness, PL10.1.12
550-Sheet Feeder, PL13.1.1
Feed Roll, PL13.2.10
Optional Feeder Board, PL13.3.6
Optional Feeder Drive Assembly
PL13.3.10
Retard Roll, PL13.4.10
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the paper tray for correct
1
installation.
2. Is the tray correctly installed?
Does the error still occur when the
2
printer is turned On?
1. Check the Feed Rollers and Retard
3
Rollers for rotation.
2. Do the Rollers rotate smoothly?
1. Check the wiring harness
4
connectors P/J422, P/J4221, and P/
J4222 between the Tray 3 Feeder
Board and the Tray 3 Feeder Drive.
2. Are the connectors securely
connected?
072-216: Option Feeder Motor Failure
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit and Feeder" on
page 10-11
"Map 4 - LVPS and MCU Board" on
page 10-13
"Map 6 - Optional 550-Sheet Feeder" on
page 10-15
"Optional 550-Sheet Feeder Wiring
Diagram" on page 10-45
Error Messages and Codes
Yes No
Go to step 3. Reseat the
paper tray.
Go to step 2.
Go to step 3. Complete.
Go to step 4. Replace the
defective
Roller(s).
Go to step 5. Reconnect the
connectors.
Go to step 5.
3-91