Phaser 6180MFP Multifunction Printer Service Manual
Regi Sensor
1.
Enter the Service Diagnostic menu (page 4-5).
2.
Remove Tray 2.
3.
Perform the Regi Sensor test:
Test
>
Regi Sensor
4.
Insert one sheet of paper in between the Registration Chute and the Turn
Clutch until the paper stops.
5.
Slowly pull out the sheet of paper while checking the information on the
Control Panel display. The Low and High values change from 0 up to 99.
Control Panel
6.
Press the Stop button to stop the Regi Sensor test.
Printer Diag
> OK.
Normal
Regi Sensor
L-0
General Troubleshooting
>
Engine Diag
>
Sensor
Regi Sensor
H-0
s6180mfp-162
4-43