Error Messages and Codes
Copier Error
3-180
The Copier has failed. The following troubleshooting procedure applies to this
error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Scanner Controller Board, PL9.1.1
ADF Scanner Assembly, PL11.1.1
Troubleshooting Procedure Table
Step
Actions and Questions
1. Check the error.
1
2. Does the error message disappear
within 70 seconds automatically, or
disappear after pressing the OK
button?
2
1. Check the error.
2. Does the error still occur when
copying or scanning?
1. Print a Configuration page:
3
>
Configuration.
2. Does the error still occur when
copying or scanning the
Configuration report?
1. Turn the printer Off and back On.
4
2. Does the error still occur when
copying or scanning?
1. Replace the Scanner Controller
5
Board (page 8-99).
2. Does the error still occur when
copying or scanning?
062-790: Scanner Parameter Error
System
Information Pages
>
Phaser 6180MFP Multifunction Printer Service Manual
Wiring and Plug/Jack Map References
Yes
Go to step 2.
Go to step 3.
Go to step 5.
To to step 5.
Replace the ADF
Scanner
Assembly
(page 8-103).
No
Go to step 4.
To to step 4.
Complete.
Complete.
Complete.