Fuser Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Fuser Error

3-50
The Fuser temperature regulation has failed. The following troubleshooting
procedure applies to this error.
Warning
The Fuser may be hot. Turn the printer power Off and allow at least 5
minutes for the Fuser to cool before removing the Fuser.
Applicable Chain Link
Chain Link
Initial Actions
Ensure that the Fuser latches are fully locked.
Cycle printer power.
If problem persists, follow the procedure below.
Troubleshooting References
Applicable Parts
Fuser, PL6.1.10
MCU Board, PL9.2.13
LVPS, PL9.2.14
LVPS Harness, PL10.1.3
Fuser Harness, PL10.1.5
Troubleshooting Procedure
Step Actions and Questions
1. Check the Fuser for correct installation.
1
2. Is the Fuser correctly installed?
Does the error still occur when the printer is
2
turned On?
1. Check the wiring harness connectors P/
3
J17, P/J171, P/J47, P/J501, and P/J14
between the MCU Board and the Fuser
Unit.
2. Are the connectors securely connected?
010-397: Fuser Error (IOT Fuser Failure)
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
page 10-10
"Map 4 - LVPS and MCU Board" on
page 10-13
"Fuser" on page 10-40
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Reseat the
Fuser
(page 8-12).
Go to step 2.
Go to step 3. Complete.
Go to step 4. Reconnect
the
connectors.