Load Tray 2 (Paper Size Mismatch) - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Load Tray 2 (Paper Size Mismatch)

3-72
The paper size mismatch is detected in Tray 2. The following troubleshooting
procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Inspect the tray to ensure that it is free of obstructions, is loaded with
supported paper, and the guides are adjusted correctly.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Tray 2, PL2.1.1
Tray 2 Retard Roll, PL2.2.17
Tray 2 Size Switch, PL7.1.18
MCU Board, PL9.2.13
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the paper size.
2. Does the paper size meet the
specifications?
2 1. Check the paper size setting.
2. Does the paper match with the
settings on the printer Control
Panel?
Does the error still occur when
3
printing?
1. Reseat the Tray Paper End Guide.
4
2. Does the error still occur?
5 1. Replace Tray 2.
2. Does the error still occur when
printing?
024-910: Load Tray 2 (IOT Paper Size Mismatch)
Wiring and Plug/Jack Map Reference
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Replace the
paper with the
correct
specifications.
Go to step 4. Correct the
paper settings
on the printer
Control Panel.
Go to step 4. Complete.
Go to step 5. Complete.
Go to step 6. Complete.