Macphy External Loop Test Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

MACPHY External Loop Test Error

3-156
MACPHY External Loop Test error has occurred. The following
troubleshooting procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL9.1.27
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Reboot the printer.
2. Does the error still occur?
2 1. Reseat the Image Processor Board.
2. Does the error still occur?
116-394: MACPHY Ext Loop Test Error (Diag Mode)
Wiring and Plug/Jack Map References
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Complete.
Replace the Complete.
Image
Processor Board
(page 8-90).