File Size Limit - Xerox Phaser 6180MFP Service Manual

File Size Limit

Phaser 6180MFP Multifunction Printer Service Manual
File size error is over the maximum file size in file conversion. The following
troubleshooting procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Scanner Controller Board, PL9.1.1
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Turn the printer power Off and back
On.
2. Does the error still occur?
2 1. Check the Country setting
information on the Control Panel:
System
Settings
2. Is the Country setting correct?
3 1. Check the Scanner Controller Board
for correct installation. Reseat the
Scanner Controller Board
(page 8-99).
2. Does the error still occur when the
printer is turned On?
016-986: File Size Limit (File Size Error)
Wiring and Plug/Jack Map References
> Admin Menu > Fax
> Country.
Error Messages and Codes
Yes No
Go to step 2. Complete.
Go to step 3. Change the
Country Setting
to the correct
country.
Replace the Complete.
Scanner
Controller Board
(page 8-99).
3-173