Invalid Job - Xerox Phaser 6180MFP Service Manual

Invalid Job

Phaser 6180MFP Multifunction Printer Service Manual
The controller has detetected incorrect data for the printing condition. The
following troubleshooting procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the paper size.
2. Does the paper meet the
specifications?
1. Check the paper size setup on the
2
Control Panel:
Settings
Size.
2. Does the paper size in use match the
settings on the printer Control
Panel?
3 1. Set the paper size settings in the
Control Panel to match the paper in
the tray.
2. Does the error still occur when
printing?
016-799: Invalid Job (Job Environment Violation)
Wiring and Plug/Jack Map References
System > Tray
> Tray 1/Tray 2 > Paper
Error Messages and Codes
Yes No
Go to step 2. Replace the
paper.
Complete. Go to step 3.
Replace the Complete.
Image
Processor Board
(page 8-90).
3-113