Xerox Phaser 6180MFP Service Manual page 215

Phaser 6180MFP Multifunction Printer Service Manual
Troubleshooting Procedure Table (continued)
Step Actions and Questions
1. Perform the Registration Sensor
5
test (page 4-43):
Printer Diag >
Sensor Test >
2. Does the number on the Control
Panel increase by 1 when the
Actuator of the Registration Sensor
is activated?
6 1. Perform the Tray 3 Feed Motor test
(page 4-59): Service Mode
Printer Diag >
Test > Tray 3 Feed
2. Does the Tray 3 Feed Motor operate
properly?
7 1. Perform the Tray 3 Feed Clutch test
(page 4-59): Service Mode
Printer Diag >
Test > Tray 3 Feed
2. Does the Tray 3 Feed Clutch operate
properly?
8 1. Perform the Tray 3 Turn Clutch test
(page 4-59): Service Mode
Printer Diag >
Test > Tray 3 Turn
2. Does the Tray 3 Turn Clutch operate
properly?
9 1. Check the Retard Rollers and Feed
Roller for operation.
2. Are the rollers correctly installed?
10 1. Replace the 550-Sheet Feeder
(page 8-116).
2. Does the error still occur when
printing?
11 1. Check the wiring harness
connectors P/J27, P/J273, and P/
J419 between the Optional Feeder
Board and the MCU Board.
2. Are the connectors securely
connected?
Yes
Go to step 6.
Service Mode >
Engine Diag >
Regi Sensor.
Go to step 7.
>
Engine Diag > Motor
Motor.
Go to step 8.
>
Engine Diag > Motor
Clutch.
Go to step 9.
>
Engine Diag > Motor
Clutch.
Go to step 10.
Replace the
MCU Board
(page 8-88).
Go to step 12.
Error Messages and Codes
No
Go to step 10.
Go to step 18.
Go to step 14.
Go to step 11.
Are the rollers
contaminated?
Replace the
defective
Rollers.
Complete.
Reconnect the
connectors.
3-27