Printer Parameter Setting - Xerox Phaser 6180MFP Service Manual

Printer Parameter Setting

Phaser 6180MFP Multifunction Printer Service Manual
This function reads/writes the parameter values, errors, and life counter
values stored in the printer.
Note
Print the parameter list from the Service Diagnostics menu -
Mode > Printer Diag
registration value.
To access the Parameter menu:
1. Turn the printer power Off (if the printer is On).
2. Simultaneously press the Up Arrow and Down Arrow buttons and turn
on the printer.
3. The Service Mode menu is displayed.
4. Select Printer Diag
5. Press the Up Arrow or Down Arrow button to find Parameter. Press the
OK button.
6. Press the Up Arrow or Down Arrow button to find the appropriate item to
change (i.e., Slow Scan
7. Enter the appropriate range using the Up Arrow or Down Arrow button.
Press the OK button to save the value.
8. The new value "# *" is displayed. The
9. Press the Exit button to return to the
Arrow or Down Arrow button to find
10. Complete Exit message is displayed. Press the OK button.
11. Exit? message is displayed. Press the OK button.
12. Please wait... --> Ready
Panel.
Note
"*" = data has been saved
> Parameter > Print before changing the
and press the OK button.
KtoP). Press the OK button.
Parameter
Printer Diag
Exit Mode. Press the OK button.
messages are displayed on the printer Control
Adjustments and Calibrations
Service
menu is displayed.
menu. Press the Up
6-11