Jam At Tray 2 (Iot Feed Jam) - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Jam at Tray 2 (IOT Feed Jam)

3-24
Paper fed from Tray 2 did not reach the Registration Sensor on time. The
following troubleshooting procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Try picking paper from a different tray.
Check the paper path for obstructions or debris.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Tray 2 Retard Roller, PL2.2.17
Tray 2 Feeder Assembly, PL3.2.1
Registration Sensor, PL3.2.30
Regi Sensor Harness Assembly,
PL3.2.37
Tray 2 Feed Roller, PL3.2.53
MCU Board, PL9.2.13
Right Side Harness Assy, PL10.1.12
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the jam paper location.
1
Remove the paper.
2. Does the error still occur?
2 1. Perform the Registration Sensor
test (page 4-43):
Printer Diag
Sensor Test
2. Does the number on the Control
Panel increase by 1 when the
Actuator of the Registration Sensor
is activated?
1. Check the paper feed.
3
2. Does multiple feed occur?
071-100: Jam at Tray 2 (IOT Feeder 1 Jam)
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit and Feeder" on
page 10-11
"Map 4 - LVPS and MCU Board" on
page 10-13
"Tray 1 (MPT) and Registration" on
page 10-26
Service Mode >
> Engine Diag >
> Regi Sensor.
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Complete.
Go to step 3. Go to step 7.
Go to step 4. Go to step 5.