Fuser Crum Id Error - Xerox Phaser 6180MFP Service Manual

Fuser CRUM ID Error

Phaser 6180MFP Multifunction Printer Service Manual
The Fuser CRUM ID error is detected. The following troubleshooting
procedure applies to this error.
Warning
The Fuser may be hot. Turn the printer power Off and allow at least 5
minutes for the Fuser to cool before removing the Fuser.
Applicable Chain Link
Chain Link
Initial Actions
Ensure that the Fuser latches are fully locked.
Cycle printer power.
If problem persists, follow the procedure below.
Troubleshooting Reference
Applicable Parts
Fuser, PL6.1.10
MCU Board, PL9.2.13
Fuser Harness, PL10.1.5
Troubleshooting Procedure
Step Actions and Questions
1 1. Check the Fuser for correct installation.
Reseat the Fuser (page 8-12).
2. Does the error still occur when the printer
is turned On?
1. Check the Fuser type.
2
2. Is the Fuser for the Phaser 6180MFP?
Check the Fuser Harness for continuity.
3
1. Disconnect P/J17 from the MCU Board.
2. Disconnect P/J171 from the Fuser Unit.
3. Check continuity between P/J17 <=> P/
J171.
4 1. Replace the Fuser (page 8-12).
2. Does the error still occur when the printer
is turned On?
010-359: Fuser CRUM Error (Fuser CRUM ID Error)
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
page 10-10
"Map 4 - LVPS and MCU Board" on
page 10-13
"Fuser" on page 10-40
Error Messages and Codes
Yes No
Go to step 2. Complete.
Go to step 3. Complete.
Go to step 4. Replace the
Fuser
Harness.
Replace the Complete.
MCU Board
(page 8-88).
3-49