Fan Motor Error (Main Fan) - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Fan Motor Error (Main Fan)

3-130
Error for the Main Fan Motor has occurred. The following troubleshooting
procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Main Fan, PL9.2.10
MCU Board, PL9.2.13
LVPS, PL9.2.14
LVPS Harness, PL10.1.3
Troubleshooting Procedure Table
Step Actions and Questions
1. Perform the Main Fan test
1
(page 4-77):
Printer Diag
Test
2. Does the Motor operate properly?
1. Check the Main Fan for correct
2
installation. Reseat the Main Fan
(page 8-84).
2. Does the error still occur when the
printer is turned On?
3 Check the LVPS Harness for
continuity.
1. Disconnect P/J501 from the LVPS.
2. Disconnect P/J14 from the MCU
Board.
3. Check continuity between P/J501
<=> P/J14.
4 1. Replace the Main Fan (page 8-84).
2. Does the error still occur when the
printer is turned On?
042-358: Fan Motor Error (IOT Fan Motor Failure)
Wiring and Plug/Jack Map References
page 10-10
page 10-13
Service Mode >
> Engine Diag > Motor
> Fan.
Phaser 6180MFP Multifunction Printer Service Manual
"Map 1 - Electrical and Drive" on
"Map 4 - LVPS and MCU Board" on
"DC Power Supply" on page 10-24
Yes No
Replace the Go to step 2.
MCU Board
(page 8-88).
Go to step 3. Complete.
Go to step 4. Replace the
LVPS Harness.
Go to step 5. Complete.