Network Not Ready Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Network Not Ready Error

3-170
The network is not ready. The following troubleshooting procedure applies to
this error.
Applicable Chain Link
Chain Link
Ready)
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Scanner Controller Board, PL9.1.1
Image Processor Board, PL9.1.20
Multi-Protocol Card, PL9.1.23
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the network connection using
ping command.
2. Does the printer connect to the
network?
1. Check the Address Book setting:
2
System
Book
2. Is the Address Book setting correct?
3 1. Check the printer specification.
2. Does the printer specification meet
the server specification?
4 1. Check the Scanner Controller Board
for correct installation. Reseat the
Scanner Controller Board
(page 8-99).
2. Does the error still occur when
connecting to the server?
1. Check the network connection.
5
Reseat the network connector.
2. Does the error still occur?
016-790: Network Not Ready Error (F2N Module is not
Wiring and Plug/Jack Map References
> Admin Menu > Address
> Speed Dial/Group Dial.
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Go to step 5.
Go to step 3. Set the correct
Address Book
information.
Go to step 4. Change the
server.
Replace the Complete.
Scanner
Controller Board
(page 8-99).
Go to step 6. Complete.
If an MPC Card
is not installed,
go to step 7.