Parameter Setting; Fax/Scanner Parameter Setting - Xerox Phaser 6180MFP Service Manual

Adjustments and Calibrations

Parameter Setting

Fax/Scanner Parameter Setting

6-10
This function reads and writes parameter stored in the Scanner Controller
Board.
Note
Refer to "Chain Link for Fax Parameter Setting" on page A-9 in the
Reference chapter.
To access the Parameter menu:
1. Turn the printer power Off (if the printer is On).
2. Simultaneously press the Up Arrow and Down Arrow buttons and turn
on the printer.
3. The Service Mode menu is displayed.
4. Select Fax/Scanner Diag
5. Press the Up Arrow or Down Arrow button to find Parameter. Press the
OK button.
Note
Use the Left or Right Arrow button to move the cursor. Use the Up or
Down Arrow button to change the value.
6. Enter the Chain Link number and press the OK button.
7. The value of the parameter is displayed with an *. This is the current
value.
8. Enter the appropriate value and press the OK button.
9. Press the Stop button three times to return to the
10. Press the Up Arrow or Down Arrow button to find Complete. Press the
OK button two times to exit.
and press the OK button.
Phaser 6180MFP Multifunction Printer Service Manual
Parameter menu.