Xerox Phaser 6180MFP Service Manual page 325

Phaser 6180MFP Multifunction Printer Service Manual
Troubleshooting Procedure Table (continued)
Step Actions and Questions
Does the error still occur when the
5
printer is turned On?
6 Check the Right Side Harness for
continuity.
1. Disconnect P/J25 from the MCU
Board.
2. Disconnect P/J251 from the Feed
Drive Assembly.
3. Check continuity between P/J25 <=>
P/J251.
Check the Drive Assembly signal.
7
1. Disconnect P/J25 from the MCU
Board.
2. Is there +24 V across ground <=>
J25-1/J25-2 pin on the MCU Board
when the Interlock Switch is
activated?
Error Messages and Codes
Yes No
Go to step 6. Complete.
Go to step 7. Replace the
Right Side
Harness.
Replace the Replace the
Feed Drive MCU Board
Assembly (page 8-88).
(page 8-78).
3-137