Xerox Phaser 6180MFP Service Manual page 208

Error Messages and Codes
3-20
Troubleshooting Procedure Table (continued)
Step Actions and Questions
1. Reseat the paper in the tray.
4
2. Does the error still occur?
1. Check the paper transfer path.
5
2. Are there any debris on the paper
transfer path?
1. Perform the Registration Sensor
6
test (page 4-43):
Printer Diag >
Sensor Test >
2. Does the number on the Control
Panel increase by 1 when the
Actuator of the Registration Sensor
is activated?
7 1. Perform the Tray 2 Motor test
(page 4-56): Service Mode
Printer Diag >
Test > Tray 2 Motor.
2. Does the motor operate properly?
8 1. Perform the Tray 2 Feed Clutch test
(page 4-68): Service Mode
Printer Diag >
Test > Tray 2 Feed
2. Does the Feed Clutch operate
properly?
9 1. Check the wiring harness
connectors P/J23, P/J232, and P/
J2322 between the MCU Board and
the Registration Sensor.
2. Are the connectors securely
connected?
10 Check the Registration Sensor
Harness for continuity.
1. Disconnect P/J2322 from the
Registration Sensor.
2. Disconnect P/J232 from the Right
Side Harness.
3. Check continuity between P/J232
<=> P/J2322.
11 Check the Right Side Harness for
continuity.
1. Disconnect P/J23 from the MCU
Board.
2. Disconnect P/J232 from the
Registration Sensor Harness.
3. Check continuity between P/J23 <=>
P/J232.
Yes
Go to step 5.
Remove the
debris.
Go to step 7.
Service Mode >
Engine Diag >
Regi Sensor.
Go to step 8.
>
Engine Diag > Motor
Replace the
> MCU Board
Engine Diag > Motor (page 8-88).
Clutch.
Go to step 10.
Go to step 11.
Go to step 12.
Phaser 6180MFP Multifunction Printer Service Manual
No
Complete.
Go to step 6.
Go to step 9.
Go to step 16.
Go to step 13.
Reconnect the
connectors.
Replace the
Registration
Sensor
Harness.
Replace the
Right Side
Harness.