Jam At Tray 1 (Mpt) - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Jam at Tray 1 (MPT)

3-30
Paper fed from Tray 1 (MPT) did not reach the Registration Sensor on time.
The following troubleshooting procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Try picking paper from a different tray.
Check the paper path for obstructions or debris.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Tray 1 (MPT) Retard Holder Kit,
PL2.1.3
Separator Roll, PL2.1.7
Tray 1 Feed Solenoid, PL3.1.3
MPT Feed Roll, PL3.1.10
Feeder Unit, PL3.2.1
Turn Roll, PL3.2.32
Registration Sensor Harness,
PL3.2.37
Feed Drive Assembly, PL8.1.7
MCU Board, PL9.2.13
Right Side Harness, PL10.1.12
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the paper condition.
2. Is the paper damaged?
1. Check the paper setting.
2
2. Does the paper in use match with
the paper settings on the printer
Control Panel?
Does the error still occur when
3
printing?
075-100: Jam at Tray 1 (IOT MPT Jam)
Wiring and Plug/Jack Map Reference
"Map 2 - Laser Unit and Feeder" on
page 10-11
"Map 4 - LVPS and MCU Board" on
page 10-13
"Tray 1 (MPT) and Registration" on
page 10-26
"Feeder" on page 10-30
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Replace the Go to step 2.
paper.
Go to step 3. Correct the
paper settings
on the printer
Control Panel.
Go to step 3.
Go to step 4. Complete.