Insert Tray 3 - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Insert Tray 3

3-78
The Tray 3 Size Switch indicates that Tray 3 is not installed. The following
troubleshooting procedure applies to these errors.
Applicable Chain Link
Chain Link
Chain Link
Initial Actions
Remove the tray and inspect the tray cavity to ensure that it is free of
obstructions or debris.
Reinstall the tray and cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL9.2.13
550-Sheet Feeder, PL13.1.1
Tray 3 Size Switch, PL13.3.5
C2 Chute Harness, PL13.3.7
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the tray for correct
1
installation.
2. Is Tray 3 correctly installed?
2 Does the error still occur when the
printer is turned On?
1. Perform the Tray 3 Paper Size test
3
(page 4-53):
Printer Diag
Sensor Test
2. Does the Switch operate properly?
024-947: Insert Tray 3 (Tray Missing)
024-947: Insert Tray 3 (Tray Detached)
Wiring and Plug/Jack Map References
"Map 6 - Optional 550-Sheet Feeder" on
page 10-15
"Optional 550-Sheet Feeder Wiring
Diagram" on page 10-45
Service Mode >
> Engine Diag >
> Tray3 Paper Size.
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 3. Reseat tray 2.
Go to step 3. Complete.
Complete. Go to step 4.