Fax Errors; Memory Full - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Fax Errors

Memory Full

3-184
The Scanner Controller Board does not have enough memory allocation. The
following troubleshooting procedure applies to these errors.
Applicable Chain Link
Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Scanner Controller Board, PL9.1.1
ADF Scanner Assembly, PL11.1.1
Troubleshooting Procedure Table
Step Actions and Questions
1. Turn the printer power Off and back
1
On.
2. Does the error still occur when
receiving fax?
1. Check the stored data on the printer:
2
System
Stored
2. Are there any stored data?
017-970: Memory Full (AIOC Lack of Memory)
033-503: Memory Full
Wiring and Plug/Jack Map References
> Information Pages >
Documents.
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Complete.
For the Go to step 3.
Delayed Start,
wait until the
data will be sent.
For the
Delayed Print,
print the stored
data.
For the Secure
Receive, enter
password to
print.