Network Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Network Error

3-116
Failure occurred on the Image Processor Board. The following
troubleshooting procedure applies to these errors.
Applicable Chain Link
Chain Link
Fail)
Chain Link
Parity/RAM R/W Error)
Chain Link
Loopback Error)
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the Image Processor Board
for correct installation.
2. Is the Image Processor Board
correctly installed?
Does the error still occur when the
2
printer is turned On?
116-350: Network Error (On Board Network Communication
116-351: Network Error (On Board Network Ethernet BIST
116-352: Network Error (On Board Network Internal
116-355: Network Error (On Board Network Fatal Error)
Wiring and Plug/Jack Map References
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Reseat the
Image
Processor
Board
(page 8-90).
Go to step 2.
Replace the
Complete.
Image
Processor Board
(page 8-90).