Nvm Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

NVM Error

3-190
NVM error has occurred. The following troubleshooting procedure applies to
these errors.
Applicable Chain Link
Chain Link
Chain Link: Controller Initialized NVM
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Scanner Controller Board, PL9.1.1
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Turn the printer power Off and back
On.
2. Does the error still occur?
1. Check the Country setting
2
information on the Control Panel:
System
Settings
2. Is the Country setting correct?
3 1. Check the Scanner Controller Board
for correct installation. Reseat the
Scanner Controller Board
(page 8-99).
2. Does the error still occur when the
printer is turned On?
117-363: NVM Error (NVM Sum Check Error)
Wiring and Plug/Jack Map References
> Admin Menu > Fax
> Country.
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Complete.
Go to step 3. Change the
Country Setting
to the correct
country.
Replace the Complete.
Scanner
Controller Board
(page 8-99).