Voice Card Package Contents; Tools And Hardware Required; Additional Materials Required - Comdial DXP Plus Manual

IMI66–109, Section Two

Voice Card Package Contents

The DVA voice cards (product code ACDXP-VCC-4)
that you install in the DVA are also separately
available.

Additional Materials Required

You will need to supply the following items:
25-pair cable and 6-wire cable for house wiring,
66-type station connector block,
four or eight foot section of 3/4–inch thick plywood
backboard, four #8 x 3/4–inch wood screws,
AC power surge protector (recommended).
Mounting Considerations
Attach the DVA cabinet vertically to any sturdy, flat
surface or vertically rack-mounted if desired. Vertical
mounting promotes proper convection air current flow
for cooling purposes.
Because of the current listing requirements of UL
1459, the length of the AC line cord on the equipment
cabinet is a maximum length of five feet; therefore,
the cabinet must be located within four feet of a proper
electrical outlet. The equipment requires a dedicated
117VAC 15 AMP circuit, with a third-wire ground,
supplied to a standard electrical outlet (NEMA
5-15R).
2 – 2 Installing The QuickQ System
Installing The QuickQ System

Tools And Hardware Required

•
Fasteners—wood screws, toggle bolts, or -wall
anchors
•
Screwdriver—to match fasteners
•
Electric drill—if prepared holes are required
•
Connecting tool—for fastening wires to a 66-type
connector block
•
Crimping tool—for 623-type modular plugs
Be sure that the mounting location is secure, dry,
provides adequate ventilation, and is not exposed to
direct sunlight or a strong magnetic field. Be sure that
the temperature range of the location is within 32-122
degrees F (0-35 degrees C), and the relative humidity
is less than 90 percent non-condensing.
If the mounting surface is damp or if it is of a concrete
or masonry material, you must attach a backboard to
the mounting surface to be used for equipment
mounting. Suitable mounting backboards are
available commercially or you can construct one using
3/4-inch plywood cut to size.