Figure 3-6. Connecting The Quickq Proteckey; Connecting Ac Power To The Dva - Comdial DXP Plus Manual

IMI66–109, Section Three
Connecting The QuickQ PROTECKEY
You must connect the supplied QuickQ PROTECKEY to the computer's parallel port. Refer to Figure 3-6 for
details.
The system will not function if you fail to connect the QuickQ PROTECKEY.

Connecting AC Power To The DVA

Before applying power to the DVA check all wiring
connections and ensure that you have properly
configured the Voice Channel Card as described in
Section 6, Reviewing The QuickQ DVA Components.
Always employ a dedicated 117VAC 15 AMP circuit,
with a third-wire ground, supplied to a non-switched
standard electrical outlet (NEMA 5-15R) for the AC
power connection. For added equipment protection,
3 – 8 Wiring The QuickQ System
CAUTION
Rear View of
Typical Personal
Computer (PC)
QuickQ
ProtecKey

Figure 3-6. Connecting The QuickQ PROTECKEY

Parallel Port
25-Pin D Connector
connect a plug-in power line surge protector between
the power cord and the AC outlet.
Be sure that the DVA is switched off, and connect the
AC power per this procedure:
plug the female end of the AC power cord into the
1.
power supply receptacle located on the left side of
the QuickQ DVA,
2. plug the male end of the AC power cord into the
power line surge protector.
Wiring The QuickQ System
CAJS031D