Requesting Information On Trunk Assignments - Comdial DXP Plus Manual

IMI89–207
4.6

Requesting Information On Trunk Assignments

Make this request to receive information on the trunk assignments that have been made. Upon making
this request, the system provides you with the following information:
•
trunk type (ground start, DID, E&M, or loop start),
•
dial type (rotary or tone),
•
signalling protocol (immediate, wink, delay).
4.6.1 Setting The DIP Switches For Requesting Trunk Assignment Information
Set the DIP switches as shown in the following table to request trunk assignment information. Use
switches 4 through 8 (designated in the table by A through E) to select the channel you want to test
(1 through 24). See the table in section 4.1.1 for the relationship between the 24 different letter groups
and channel numbers. For remote operation, determine the corresponding hex code from Table 1. Switch
1 is the top switch.
SWITCH SETTINGS
1 2 3
ON OFF ON
4.6.2 Reading The Trunk Assignment Information From The LEDs
The Table below shows the trunk assignment information that is revealed by the LEDs. LED 1 is at the
top.
1 2 3
ON OFF OFF
ON ON OFF
OFF ON OFF
OFF OFF ON
OFF OFF OFF
18 – Troubleshooting The DXPT1 Installation
4 5 6 7 8 Provide information about trunk
A B C D E
LEDs
4 5 6 7
OFF
OFF
OFF
OFF
ON
OFF
OFF OFF
OFF ON
ON OFF
ON ON
OFF OFF OFF OFF OFF
Troubleshooting The DXPT1 Installation
TYPE OF REQUEST
assignments on the channel specified by the
letters ABCDE (see the table in section
4.1.1).
LED DEFINITIONS
8
Ground start
DID
E&M
Loop start
Tone dial
Not used
Wink start
Delay start
Immediate start
Not used
No trunk assignments made
HEX
CODE
see
Table
1