Programming And Using Mini-Dss Buttons - Inter-Tel CS-5200 Administrator's Manual

INTER-TEL
To erase System Speed Dial names or numbers:
1.
2.
3.
4.

Programming and Using Mini-DSS Buttons

Direct Station Select (DSS) buttons, located on a Mini-DSS unit or on an Inter-Tel phone, pro-
vide one-button access to extension numbers. If the button is equipped with a lamp, you can
visually monitor the status of the associated extension. Mini-DSS buttons are not available on
single line phones.
NOTE
Together, the lamps in the buttons create a busy lamp field that indicates the status of the
resource (e.g., endpoint, trunk, hunt group, or feature) assigned to the buttons. The table shown
below explains what Mini-DSS lamps indicate about the associated resource.
Table 7:
IF THE LAMP IS . . .
Solidly Lit
Slow Flash
Fast Flash
Continuous
Flutter
In Database Programming, Mini-DSS buttons may also be programmed for direct access to
other resources such as paging zones, or they can be assigned feature codes. Refer to "End-
point Feature Codes" on
status of the resource or feature.
NOTE
Programming and Using Mini-DSS Buttons
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
While on-hook, enter the Program System Speed Dial feature code (9801). Display
phones show PROGRAM SYS SPD # (000–999).
Enter the Speed Dial location code (000–999). The display shows ENTER NAME:
<current name>.
You may erase the name and/or number:
To erase the name: Press
To erase the number: Press
then press repeatedly until the number is erased or press
MUTE
Press or ACCEPT to exit. You hear a single progress tone when accepted. Your dis-
#
play shows SYS SPD BIN #XXX UPDATED.
You can program a DSS button for an off-node device, but not for "wildcard" off-
node extensions.
Mini-DSS Lamp Meanings
The associated resource is busy or all phones in the associated hunt
group are unavailable in Do-Not-Disturb, busy, or with hunt group
remove enabled. Or, the associated feature is enabled.
The associated resource is in Do-Not-Disturb.
The associated resource has a call ringing in or a call is camped on
to the hunt group. This option is programmable. If DSS ring flash is
disabled, a call ringing in to a phone shows a solidly lit lamp.
The associated resource is causing an ENDPOINT OFF-HOOK sys-
tem alarm.
page 119. Busy lamp indication is provided to show the idle or busy
Programming a Mini-DSS button as a resource does not always provide a trans-
fer capability. For example, a Mini-DSS button programmed for paging will not
transfer a party to the paging system.
repeatedly until the name is erased or press
MUTE
or ACCEPT to display the ENTER NUMBER prompt,
#
THEN . . .
Administrator Procedures
CLEAR
.
CLEAR
Page 47
.